News & Insights


More To Do With Our IFC Green Build

Carl Christianson

One question that pops up with ICF foundation houses is concerning the  flexibility of making changes during the project. How easy is it to change things once the ICF’s have been set? Answer: this is very difficult and time consuming. Below will help to explain some of the problems with changes while under construction.

Recently we have run into a few snags on this project where the plans have not been quite as clear as we needed. Wall evelations and window sizing specifically, are required at the forefront of construction on ICF homes. When ICF walls go up there is little room for changes after the fact. Careful consideration goes into laying out walls, windows and doors before any block is laid due to the huge amount of time it takes to change after the ICF system has been assembled. Think of these blocks as large Legos. Adding a window or door in a wall or moving one is not as simple as in filling the old one and cutting a new one for reasons listed below.

ICF blocks are fabricated to have internal webbing between the foam forms. While the foam offers the amazing insulation values, the webbing offers rigidity to the forms and also serves to supports re-bar within the foam as well as providing an attachment point for both interior finishes such as Sheetrock and exterior such as siding.

The internal re-bar becomes part of the ICF structure and is laid with every course of the ICF walls. Once laid it is wired in place to the webbing to help stabilize the walls and prevent shifting of the block as well as adding structuralstrength to the concrete that will be poured within the open cells. When changes are made to this system you may have to remove each layer of ICF block to get to the area where the change occurs. Remembering that each layer has re-bar that must be snipped, pulled then replaced as well as the fact that webbing lines must remain centered over one another to stay on layout. Since re-bar is overlapped  by 2′ on each end and is often placed in in 16′ pieces, you can imagine how one small change can mean a large amount of forms being pulled and work to be done. Once the change area is reached, the shifting will most likely require the cut portions to be discarded so as to retain a factory end. ICF ends are also keyed into one another and a cut peice must be discarded unless it can be re cut to a smaller length and re-used. at $20 each this change can get expensive just in material quick. While the blocks can be reused if pulled apart carefully there is also the risk of damaging them while doing so and then the blocks do not reconnect with the same precision often requiring the last course to be altered to avoid elevation changes in nthe wall.

Another consideration effecting window and door placement is how tight ICF blocks need to be fitted to the window and door block outs called “bucks”. These block outs must be within 1/4″ of the cut foam and then foam filled to the wood support prior to pouring the walls. Reinforcement and stiff backs must be added in these locations as often the web of the ICF blocks has been weakened due to cutting the block down in these areas. Where internal webbing has been cut due to the window or door laying out in the middle instead of the end of a block careful attention must be made to prevent blow outs of the weakened block units.

When having to alter ICF or make many cuts in the ICF systems due to non conforming layouts with the ICF options it can triple or more the effort and time required. When all information is available early, the ICF is the fasted way to build both foundation and walls. One 2400 square foot house recently done took 14 days from footing to completion and day 18 saw the trusses being set and dry in starting. This project also had ell electrical in the walls at time of ICF block setting and a total of 22 windows and three exterior doors.  Note that the design of this house also utilized jogs and offsets that allowed the use of standard ICF blocks without customizing.

x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security